Step 1: Your Vinyl Sticker will have a Transfer Tape (usually semi-transparent or checkered) on top.

Step 2: Use a scraper to burnish the vinyl firmly before peeling the transfer and the vinyl away from the background (vinyl liner)

Step 3: Plan where you want to place your vinyl.

Step 4: Ensure the project surface is clean and dry by wiping it with a cloth.. 
Before you start, use a laser level or a tape measure with a built-in level to mark a straight reference line on the wall. This ensures your vinyl decal goes on perfectly straight.

Step 5: Position the vinyl on the wall
Place your vinyl decal on the wall in the desired position, aligning it with the reference line.

Step 6: Secure the center with masking tape; Apply a strip of white masking tape vertically down the center of the design, dividing it into two halves. This tape acts as a hinge, keeping the decal aligned while you work on each side.

Step 7: Apply the first half : Lift one half of the decal. Peel off the liner (backing paper) from that side and cut it off.

Step 8: Use a squeegee or card to burnish (press and smooth) the vinyl from the center out toward the edges, sticking it to the wall without bubbles.

**It is common for parts of your design to remain attached to the Transfer Tape. TIP: For stubborn designs, use a heat source (e.g., a hairdryer) to soften the adhesive, depending on the surface.

Step 9: Apply the second half : Remove the masking tape from the centre.

Step 10: Lift the other half and peel away the remaining liner slowly and carefully and use your card again to burnish the vinyl from the center out to the edges.

Step 11: Finishing touch; Go over the entire design once more with the card to ensure good adhesion — and you’re done!
Your vinyl decal is now perfectly straight, smooth, and professionally applied.